JVC 0504CSH-ID-VT, LPT0970-001A manual Manual Channel Set

EN 69

●Using the Confirmation screen, you can skip or add channel positions, enter station names and perform other operations. Refer to pages 69 – 71 for the procedures.

●Depending on reception conditions, the stations may not be stored in order, and the station names may not be stored correctly.

●For information on scrambled broadcasts, refer to page 70.

IMPORTANT

●In certain reception conditions, station names may not be stored correctly, and Auto Guide Program Number Set may not work properly. If the Guide Program numbers are not set properly when you timer-record a TV programme using the SHOWVIEW system, the unit will record a TV programme of a different station. When programming the

timer using the SHOWVIEW system, be sure to check the desired channel is selected correctly. ( pg. 24, “SHOWVIEW® Timer Programming”) (VHS deck only)

●Your unit memorizes all detected stations even if reception

of some of them is poor. You can delete those stations with an unacceptable picture. ( pg. 70, “Delete A Channel”)

NOTES:

●Fine tuning is performed automatically during Auto Channel Set. If you want to perform tuning manually, refer to page 71.

●If you perform Auto Channel Set when the aerial cable is not connected properly, “SCAN COMPLETED –NO SIGNAL–” appears on the TV screen in step H. When this happens, make sure of the aerial connection and press OK; Auto Channel Set will take place again.

●If no sound accompanies the picture or the audio sounds unnatural on some channels that have been stored by Auto Set Up, the TV system setting for those channels may be incorrect.

Select the appropriate TV system for those channels. ( pg. 70, “INFORMATION”)

Manual Channel Set

Store channels that were not stored during Auto Set Up

( pg. 10), Preset Download ( pg. 12) or Auto Channel Set ( pg. 68).

A Access the Main Menu screen.

Press SET UP MENU.

B Access the Confirmation screen.

Press rt to move the highlight bar (pointer) to “MANUAL CH SET”, then press OK or e. The Confirmation screen appears.

C Select the channel position.

Press rt w e until an open (Example) To store in position 12.

position in which you want to store a channel begins blinking, then press OK. The Manual Channel Set screen appears.

● The blueback screen and the programme currently being broadcast by the selected channel appear alternately for 8 seconds each.

D Select the band.

Press rt to change the band between CH (regular) and CC (cable), then press e.

E Input the channel.

Press the number keys to input the channel number you want to store.

●Input “0” before any single number entries.

●To input the registered station name (ID –  pg. 72), press e until “– – – –” (ID setting) begins blinking, then press rt.

●For fine tuning adjustment, press e until “+/–”begins blinking, then press rt. While tuning, “+” or “–” appears.

●When storing a channel that sends scrambled broadcasts, press e until “OFF” (Decoder setting) blinks, then press rt to set “DECODER” to “ON” (“OFF” is the default setting).

●When “L-2 SELECT” is set to “A/V” or “SAT”, the “DECODER” setting cannot be changed. ( pg. 64)

F Enter new channel information.

Press OK and the Confirmation screen appears.

●Repeat steps C – F as necessary.

G Close the Confirmation screen.

Press SET UP MENU.

●To change positions, see “Change Station Channel Position” ( pg. 70).

●If you wish to set station names other than the ones registered in your unit, see “Set Stations (B)” ( pg. 71).

ATTENTION

Guide Program numbers are not set when channels are stored manually. ( pg. 24, “SHOWVIEW® Timer Programming”)