JVC LPT1100-001A manual Edit From a Camcorder, If the camcorder has no S-VIDEO output connector

EDITING EN 61

Edit From A Camcorder		● Slide the TV/CABLE/SAT/DVD switch to DVD.
You can use a camcorder as the source player and your unit as the		1 Make connections.
		A If the camcorder has no S-VIDEO output connector:
recording deck. If your camcorder has a DV IN/OUT connector, you
		^ connect the camcorder’s AUDIO/VIDEO OUT connectors to
can use the camcorder as the recording deck and your unit (DV
		the unit’s [VIDEO/AUDIO ((MONO) L/R)] input connectors
deck only) as the source player.
		on the front panel.
A If the camcorder has no S-VIDEO output connector:		● When using a monaural camcorder, connect its AUDIO OUT
		connector to the [AUDIO-L] input connector on your unit.
		B If the camcorder has an S-VIDEO output connector:
		^ connect the camcorder’s AUDIO OUT and S-VIDEO OUT
		connectors to the unit’s [AUDIO] and [S-VIDEO] input
		connectors on the front panel.
		C If the camcorder has a DV IN/OUT connector:
To [VIDEO/AUDIO	Recorder	^ connect the camcorder’s DV IN/OUT connector to the unit’s
((MONO) L/R)] input		[DV IN/OUT] connector.
		● When using your unit as the source player, refer to the
Audio/video cable		camcorder’s instruction manual for the recording procedure.
		2 Press DV/HDD/DVD SELECT on the unit repeatedly to select
(not supplied)

the recording deck.

AUDIO/VIDEO OUT

Player

BIf the camcorder has an S-VIDEO output connector:

To [S-VIDEO]	To [AUDIO] input	Recorder
input

S-video cable		Audio cable
(not supplied)	S-VIDEO OUT	(not
		supplied)

3Press PR +/– to select AF-1B or ADVB.

●Set AF-1 INPUTB to AVIDEOB for the [VIDEO] input connector, or AS-VIDEOB for the [S-VIDEO] input connector, depending on the connector being used. (A pg. 64)

4Press REC MODE repeatedly to set the recording mode. For DV deck, press REC MODE on the remote control to set the recording mode.

5Start playback on the camcorder slightly before the actual point from where you wish to start dubbing.

6Press R on the unit to start recording. Or while holding R, press I on the remote control. The dubbing starts.

7Press o on the unit, then stop playback on the camcorder.

NOTES:

●All necessary cables can be obtained from your dealer.

●Refer to the camcorder’s instruction manual for operating procedure.

●The quality of dubbed picture becomes poorer than that of the original.

●When you are editing through the [DV IN/OUT] connector, the unit will stop if the player begins playing a blank portion of tape or the signal is interrupted.

●When connecting the unit to a device equipped with a DV input connector, be sure to use the optional DV cable (VC-VDV 204U).

●To edit through the [DV IN/OUT] connector using the HDD or DVD deck, refer to ADV Dubbing (HDD & DVD Deck Only)B (A pg. 59).

AUDIO OUT

Player

CIf the camcorder has a DV IN/OUT connector:

Recorder/Player

To [DV IN]

DV cable (VC-VDV 204U)

(not supplied)

DV connector

Player/Recorder