JVC LPT1100-001A manual If the player has no S-VIDEO output connector

66 EN EDITING

	Insert Editing (DV Deck Only)				● Slide the TV/CABLE/SAT/DVD switch to DVD.
					1 Make connections.
Insert Editing replaces the pictures with new ones, while the audio
soundtrack remains unchanged. For Insert Editing, use your unit					A If the player has no S-VIDEO output connector:
					^ connect the player’s AUDIO/VIDEO OUT connectors to your
as the recording deck.
					unit’s [VIDEO/AUDIO ((MONO) L/R)] input connectors on
ATTENTION:					the front panel.
					B If the player has an S-VIDEO output connector:
Insert Editing is not possible with a Mini DV cassette recorded in
					^ connect the player’s AUDIO OUT and S-VIDEO OUT
LP mode.
					connectors to your unit’s [AUDIO] and [S-VIDEO] input
A If the player has no S-VIDEO output connector:					connectors on the front panel.
					2 Load a Mini DV cassette with the erase protection switch set to
		Your unit	PR +/-	Recorder	ARECB.
					3 Press DV/HDD/DVD SELECT on the unit repeatedly or DV on
					the remote so that the DV lamp lights up on the unit.

To [VIDEO/AUDIO	INSERT
((MONO) L/R)] input

Audio/video cable

(not supplied)

AUDIO/VIDEO OUT

Another recorder

Player

BIf the player has an S-VIDEO output connector:

Your unit PR +/- Recorder

To [S-VIDEO]	To [AUDIO] input
input	INSERT

4Press PR +/– to select AF-1B.

5Press S, T and W to determine the edit-in point (the beginning of the segment to be replaced).

●Be sure to engage the Still mode at the edit-in point.

6Press INSERT to engage the insert editing mode.

●Your unit enters the Insert Pause mode.

●The TV screen changes from the still picture to the input source you are going to record.

7Load the source cassette and play back the segment that is to

be inserted. When you reach the start of the section of the source tape that you wish to insert, press I to start the tape in your unit. Insert editing begins at this point.

8Press o to stop recording on the DV deck to end insert editing.

NOTES:

●Once the Insert Editing starts, you cannot use the other deck.

●All necessary cables can be obtained from your dealer.

●Insert Editing cannot be performed on a Mini DV cassette that has had its erase protection switch set to ASAVEB.

●When Insert Editing is performed on a tape that has been recorded on another video recorder, the inserted portion may appear distorted.

●A small portion of the recording which precedes an insert edit may become erased.

●Insert Editing is also possible with the [L-1 IN/OUT] or [L-2 IN/ DECODER] connector on the rear panel. When using these 21- pin SCART connectors, be sure to select the correct input mode (AL-1B or AL-2B) in step 4.

●Insert Editing is not possible using the [DV IN/OUT] connector.

●Insert Editing is not possible on a blank portion of the tape.

S-video cable	Audio cable
(not supplied)	(not supplied)
S-VIDEO OUT	AUDIO OUT
	Another recorder

Player