JVC Model SR-TS1U SET Recording VCR’S Input Mode, Turn on ALL Components, Prepare for Recording

JOG

SHATTLE

REC

STOP/EJECT

EN35

START RECORDING

5 Press REC on either of SR-TS1U.

When the tape reaches to the end while recording, the other SR-TS1U successively starts to record. Therefore, recording will be continued onto cassettes loaded on two SR-TS1U alternately.

The cassette will automatically be rewound when the recording stops.

Replace the cassette after rewound if you want to continue to record onto another cassette.

STOP PLAYBACK

6 Press STOP/EJECT on the SR-TS1U which is recording.

Using two sets of SR-TS1U, a long recording will be possible (such as camcorder recording, another VCR playback or TV broadcast).

Use the buttons and controls on the VCR‘s front display panel for the Series Playback operations (except when using Mode Lock).

1	MAKE CONNECTIONS
	Connect two sets of SR-TS1U to other equipment, an-
	tenna or cable as shown in the illustration on page 34.
	The mini-plug cable is a mono 3.5 mm mini-plug to
	mono 3.5 mm mini-plug connector.
	When connecting a camcorder or another VCR with
	an S-VIDEO output connector as recording source, it
	is recommended to use the S-VIDEO connection to
	minimize picture degradation.

2	TURN ON ALL COMPONENTS
	After completing the connections, turn on all the
	components.
	Set the TV to video input mode or A/V input mode.
	Refer to the TV instruction manual.

SET RECORDING VCR’S

INPUT MODE

3 Set to "AUX". Press CH 5° to select the input mode depending on the connector being used – "L-1" for the rear AUDIO/VIDEO IN connector, or "F-1" for the front AUDIO/VIDEO IN connector.

4	PREPARE FOR RECORDING
	Insert the recording cassette into each SR-TS1U, and
	prepare the playback source.
	NOTE:
	If you do not want to display the superimposed
	indication on the screen during recording, set it to
	"OFF" ( pg. 30). If the playback equipment has a
	superimpose/OSD disable feature, set its superimpose
	or display feature to "OFF" as well.

To prohibit operations during Series Recording (Mode Lock)

Press and hold OK on the remote control for more than 5 seconds. The Mode Lock indicator lights up on the front display panel ( pg. 66). The picture will be recorded onto the cassettes alternately without any interruption.

To resume the other operations, press and hold OK on the remote control again for more than 5 seconds.

NOTES:

Series Recording is also possible using the front AUDIO/ VIDEO connectors.

When recording a TV broadcast, tune in the same channel on both SR-TS1U.

If you do not want to record the superimposed operational indications on the screen during Series Recording, set the Superimpose mode both in playback and recording to "OFF". ( pg. 30)