EN 9
INFORMATION
If "AUTO CLOCK" is set to "ON" at the Clock Set screen on page 11, the clock will be adjusted automatically by the host
channel every hour on the hour (except for 11:00 PM, midnight, 1:00 AM and 2:00 AM) by the incoming PBS channel clock
setting data. (This automatic clock adjustment can only be performed when the VCR’s power is turned off. The clock will be
adjusted on the hour based on the time displayed on the VCR, not on the actual real time.) The default setting of "AUTO
CLOCK" is "ON".
If the memory backup fails, because of a power outage or because the AC was removed from the VCR, Plug & Play will be
performed when power is restored to the VCR.
What To Do If Plug & Play Has Failed
If an incorrect time is displayed on the front display panel, you may be receiving the clock setting data of a PBS channel from
an adjacent time zone, or an incorrect PBS channel from a cable TV system. In this case, perform the Semi-Auto ( pg. 11) or
Manual Clock Set ( pg. 12) procedure. Auto channel set has already taken place and it need not be set again.
If “- -:- -” appears on the display, your antenna cable may not be connected to the VCR or there may not be a Host PBS signal
available in your area. Ensure that the antenna cable is connected correctly. Then power on and power off the VCR; the Plug &
Play function will be automatically reactivated and "Auto" will be displayed on the VCR's front panel. If Plug & Play is not
performed but the antenna cable is connected correctly, perform the Manual Clock Set procedure ( pg. 12). Auto channel
set has not yet taken place, so please also perform the “Set Receivable Channels” procedure ( pg. 13).
Last-Function Memory
When the AC is removed from the VCR or when the power failure occurs, your settings for the following functions are kept in
memory. These settings will resume when the VCR is turned on again.
a- Input Selection (channel or auxiliary input; L-1 or F-1)
b- Returning Position ( pg. 28)
c- Superimpose ( pg. 30)
d- Recording Safety Mode ( pg. 39)