JVC Model SR-TS1U manual Recording Features

38EN

PLAYBACKANDRECORDINGFEATURES(cont.)

Recording Features

JOG

SHATTLE

TV/VCR

Display Elapsed Recording Time

1	RESET COUNTER TO ZERO
	Before recording starts, press C.RESET. The counter
	resets to zero and displays the exact elapsed time as the
	tape runs.
	DISPLAY ELAPSED TIME ON
2	SCREEN
	During recording, press OSD at any time to see the
	elapsed time.
	All indications corresponding to the current status of the
	VCR are displayed for 5 seconds. The counter display
	remains on the screen indicating the elapsed time.
	Press OSD again to remove the display.
	Make sure "SUPERIMPOSE" is set to "ON" ( pg. 30).
	The indications are not recorded.
	Press DISPLAY to change to the COUNT display if
	"REMAIN" is displayed.

V/VCR		OSD
		DISPLAY
1	2	3
		2
4	5	6
7	8	9
C.RESET	0	4

1

Record One Program While Watching Another

1	ENGAGE TV MODE
	During recording...
	Press TV/VCR. The VCR's VCR indicator goes out. (If
	you are using the RF connection (	pg. 6) to view
	the output from your VCR, the TV broadcast being
	recorded disappears.)
	If you are using the AV connection (	pg. 6) to view
	the output from your VCR, change the TV's input
	mode from AV to TV.

SELECT CHANNEL FOR

VIEWING

2 Use the TV’s channel selector to set the channel you want to watch.

Display Tape Remaining Time

DISPLAY COUNTER

INFORMATION

1 Press OSD.

All indications corresponding to the VCR's current status are displayed for 5 seconds. The counter display remains on the screen indicating the elapsed time.

DISPLAY TAPE REMAINING TIME

2 Press DISPLAY until "REMAIN" appears on screen. The approximate tape remaining time appears on the TV screen and also on the VCR display panel with a "" indicator.

The tape remaining time is calculated based on the tape speed (SP or EP) being used. The indicated remaining time is only an estimate.

Press DISPLAY to change the on-screen display from REMAIN to COUNT and vice versa; and to show counter reading, channel number, clock time or tape remaining time on the front display panel. Then channel number will not be displayed when the VCR is playing a tape.

EXIT THE DISPLAY

3 Press OSD again.

NOTES:

"SUPERIMPOSE" must be set to "ON", or the on-screen display will not appear ( pg. 30).

Near the beginning of the tape, the tape remaining estimate may be inaccurate. However, the estimate becomes more accurate as the tape comes closer to the end.

Depending on the type of tape used, the tape remaining time reading may not appear right away, or may not be correct. "- -:- -" may sometimes appear, or the display may blink on occasion. The tape remaining time indication is not accurate when using VHS-C tapes with VHS-C adapter.