JVC Model SR-TS1U manual Make Connections, Turn on ALL Components, Load Cassettes

EN33

PLAY

JOG

SHATTLE

STOP/EJECT

To prohibit operations during Series Playback (Mode Lock)

Press and hold OK on the remote control for more than 5 seconds. The Mode Lock indicator lights up on the front display panel ( pg. 66). The 2 cassettes will be played back alter- nately without any interruption.

To resume the other operations, press and hold OK on the remote control again for more than 5 seconds.

Using two sets of SR-TS1U, you can play back two cassettes alternately as many times as you want. You can select the returning position for Series Playback ( pg. 28)

Use the buttons and controls on the VCR‘s front panel for the Series Playback operations (except when using Mode Lock).

1

2

3

4

5

MAKE CONNECTIONS

Connect two sets of SR-TS1U and a TV using AV cables as shown in the illustration on page 32.

The mini-plug cable is a mono 3.5 mm mini-plug to mono 3.5 mm mini-plug connector.

When playing back S-VHS recordings, it is recom- mended to use the S-VIDEO connection to minimize picture degradation.

TURN ON ALL

COMPONENTS

After completing the connections, turn on all the components.

Set the TV to video input mode or A/V input mode. Refer to the TV instruction manual.

LOAD CASSETTES

Insert the playback cassette into each SR-TS1U.

Set SR-TS1U–2 to "AUX". Press CH 5° to select the input mode depending on the connector being used – "L-1" for the rear AUDIO/VIDEO IN connector, or "F- 1" for the front AUDIO/VIDEO IN connector.

START PLAYBACK

Press PLAY on either of SR-TS1U.

When the playback reaches to the returning position (tape end or recording end pg. 28), the other SR-TS1U successively starts to play. (The cassette will automatically be rewound when the playback stops.) Therefore, the cassettes loaded on two SR-TS1U will be played back alternately as many times as you want.

STOP PLAYBACK

Press STOP/EJECT on the SR-TS1U which is playing back a cassette.