JVC MX-V588T, MX-V508T manual Music Scan, Reverse Mode

Music Scan

To find the beginning of a music track during play, use the Music Scan function. Music Scan searches for blank portions that usually separate selections, then plays the next selection.

Unit/Remote Control	Steps	Explanation/Remarks
	To Find the Beginning of the Current
	Selection
	1. Press the 1 or Á or (1 or Á	1. Searching stops at the beginning of the current selec-
or	button on the Remote Control) in the op-
	posite direction to that in which the tape	tion, and the current selection starts automatically.
	is playing.
	To Find the Beginning of the Next Se-
	lection
	1. Press the 1 or Á or ( 1 or Á
	button on the Remote Control) in the
	same direction to that in which the tape
	is playing.	1. Searching stops at the beginning of the next selection,
		and the next selection starts automatically.
		Notes:
		Music scan works by detecting a 4-second long blank
		at the beginning of each selection, so it won't work
		well if your tape has:
		• No blank at the beginning of a selection.
		• Noise (tape often used or poor dubbing) which fills
		the blank with noise.
		• Long, very soft passages or pauses in a selection.
		The scan will detect these as 4-second long blanks.
		If this happens, scan again.

English

Reverse Mode

You can play both sides of a cassette, or play both the tapes in the two decks continuously.

Unit		Steps					Explanation/Remarks
	On the Unit		1. The indicator changes with each press of the button.
	1.	Press the REVERSE MODE.
	2. To change the Reverse Mode, press the		= (				) = (	) = (	)= (back to the begin-
		REVERSE MODE again.	ning)
			•	(	) : the deck stops after playing one side of the
							tape.
			•	(		) : the deck stops after playing both side of the
							tape.
			•	(			) : After playing both sides on the tape, the Unit
							will play the other tape; if there is a tape in
							the other deck.
							The tapes will play continuously over and
							over again until it is stopped.

29