Basic Settings
English
DIGITAL AUTO : Select this for the digital input mode. The receiver automatically detects the incoming signal format. (The DIGITAL AUTO indicator lights up on the display, then the digital signal indicator for the detected signals lights up.)
ANALOG : Select this for the analog input mode. (Initial setting when shipped from the factory.)
If the following symptoms occur while playing Dolby Digital or DTS Digital Surround software with “DIGITAL AUTO” selected, follow the procedure below.
•Sound does not come out at the beginning of playback.
•Noise comes out while searching or skipping chapters or tracks.
1Press INPUT DIGITAL (or ANALOG/DIGITAL on the remote control).
• “DIGITAL AUTO” appears on the display.
2 Press CONTROL UP 5/DOWN ∞ to select “DOLBY DIGITAL” or “DTS SURROUND” while “DIGITAL AUTO” still remains on the display.
•Each time you press the button, the digital input mode changes as follows:
When “DOLBY DIGITAL” or “DTS SURROUND” is selected, “DIGITAL AUTO” goes off.
|
|
|
|
|
| SPK |
|
|
|
| |
DIGITAL AUTO | L C | R | |
|
| S.WFR LFE | |
DIGITAL | LS | RS | |
|
|
|
|
DIGITAL AUTO DTS SURROUND
DOLBY DIGITAL
Setting the Speaker Information Remote
NOT
To obtain the best possible sound or effect from the Surround modes (see page 18), register the following speakers and subwoofer information after all connections are completed.
The followings are items you can set:
•Subwoofer
•Speaker
•Speaker
•Crossover
•Low frequency effect
•Dynamic range
Before you start, remember...
There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.
“YES” for the subwoofer and “SMALL” for the front, center and rear speakers are initial settings. To get best possible sound, change the subwoofer and speaker settings to fit your listening conditions.
Subwoofer information
Register whether you have connected a subwoofer or not.
1 Press SETTING repeatedly until |
|
| |
T | SETTING | ||
| |||
“SUBWOOFER” (with the current |
|
| |
|
| ||
|
| ||
|
| ||
setting) appears on the display. |
|
|
•To play back software encoded with Dolby Digital, select “DOLBY DIGITAL.”
•To play back software encoded with DTS Digital Surround, select “DTS SURROUND.”
Note:
When you turn off the power or select another source, “DOLBY DIGITAL” and “DTS SURROUND” are canceled and the digital input mode is automatically reset to “DIGITAL AUTO.”
The followings are the analog/digital signal indicators on the display to indicate what type of the signal comes into the receiver.
ANALOG : Lights when the analog input is selected.
LINEAR PCM : Lights when Linear PCM signals come in. DIGITAL : • Lights when Dolby Digital signals come in.
•Flashes when “DOLBY DIGITAL” is
selected for software not encoded with Dolby Digital signals.
: • Lights when DTS signals come in.
•Flashes when “DTS SURROUND” is selected for software not encoded with DTS signals.
Note:
When “DIGITAL AUTO” cannot recognize the incoming signals, no digital signal indicators light up on the display.
2 Press CONTROL UP 5/DOWN ∞ to CONTROL
DOWN UP
register whether you have connected a subwoofer or not.
•Each time you press the button, the subwoofer setting alternates between “YES” and “NO.”
YES : Select this when you have connected a subwoofer. You can adjust the subwoofer output level
(see page 15).
NO : Select this when you have not connected or have disconnected a subwoofer.
12