JVC RX-5020VBK, RX-5022VSL manual Connecting the Power Cord, Getting Started, Digital connections

VCR

A	VCR	C
B		D
CD
OUT		MONITOR
(REC)		OUT
TAPE
CDR
IN		DVD
(PLAY)
OUT		OUT
(REC)		(REC)
VCR		VCR
IN		IN
(PLAY)		(PLAY)

VIDEO

TV SOUND

RIGHT LEFT

AUDIO

ÅTo left/right channel audio output ı To left/right channel audio input Ç To video output

Î To video input

DVD player

	DVD player
A

IMPORTANT:

•When connecting the DVD player or digital TV using the digital terminal, you also need to connect it to the video jack on the rear. Without connecting it to the video jack, you can view no playback picture.

•After connecting the components using the DIGITAL IN terminals, set the followings correctly if necessary:

–Set the digital input (DIGITAL IN) terminal setting correctly. For details, see “Setting the Digital Input (DIGITAL IN) Terminals” on page 11.

–Select the digital input mode correctly. For details, see “Selecting the Analog or Digital Input Mode” on page 11.

Digital TV

DVD player

CD player CD recorder

When the component has a digital coaxial output terminal, connect it to the DIGITAL 1 (DVD) terminal, using the digital coaxial cable (not supplied).

DIGITAL 1 (DVD)

Getting Started

B

		MONITOR
RIGHT	LEFT	OUT
DVD		DVD
AUDIO
		OUT
		(REC)
		VCR
		IN
		(PLAY)

When the component has a digital optical output terminal, connect it to the DIGITAL 2 (CD) terminal, using the digital optical cable (not supplied).

Before connecting a digital optical cable, unplug the protective plug.

Notes:

DIGITAL 2 ( CD )

DIGITAL IN

VIDEO

ÅTo front left/right channel audio output (or to audio mixed output)

ıTo video output

Note:

To enjoy the software encoded with Dolby Digital or DTS Digital Surround, you must connect the DVD player using the digital terminal on the rear of this receiver. (See “Digital connections” below.)

Digital connections

This receiver is equipped with two DIGITAL IN terminals—one digital coaxial terminal and one digital optical terminal.

You can connect any component to one of the digital terminals using a digital coaxial cable (not supplied) or digital optical cable (not supplied).

•When shipped from the factory, the DIGITAL IN terminals have been set for use with the following components.

–DIGITAL 1 (coaxial): For DVD player

–DIGITAL 2 (optical): For CD player

•When you want to operate the CD player or CD recorder using the COMPU LINK remote control system, connect the target component also as described in “Analog connections” (see page 6).

Connecting the Power Cord

Before plugging the power cord into an AC outlet, make sure that all connections have been made.

Plug the power cord into an AC outlet.

CAUTIONS:

•Do not touch the power cord with wet hands.

•Do not pull on the power cord to unplug the cord. When unplugging the cord, always grasp the plug so as not to damage the cord.

7