Creating Realistic Sound Fields

2 3

D.R.C

REW

FF

VCR CHANNEL

TUNING

B.SEARCH F.SEARCH

ENTER

VOLUME

DVD FM/AM AUX MUTING

 

 

 

SOUND

1

2

3

 

 

 

 

SETTING

4

5

6

 

 

 

 

PRO LOGIC

7

8

9

 

SLOW

 

SETUP

TEST

0

ANGLE

ZOOM

D.R.C

DSP MODE

REPEAT A-B REPEAT PROGRAM

EFFECT

CLEAR SEARCH REMAIN SLEEP

SOUND

PRO LOGIC

DSP MODE

3To adjust the output balance for the front speakers

1) Press SOUND repeatedly until the

SOUND

adjustment indication for the front

 

speakers appears on the display.

 

Each time you press the button, the adjustment indication on the display changes as follows:

00 F 00 00 R 00 CEN

Normal indication

 

SW

 

REAR

(canceled)

 

 

 

 

 

 

2) Press 3 or 2 to adjust the output balance.

3: Decreases the left speaker

output, or restores the right

ENTER

 

speaker output.

 

2 : Decreases the right speaker

 

output, or restores the left

 

speaker output.

 

Adjusting Stereo Sound

The output balance changes from

OFF (silence), –06 (most reduction) to 00 (no reduction).

“00 F 00” is the initial setting (the output balance is at the center position). If you have already changed the setting, another value will appear.

You can adjust the following settings.

It is recommended that you make adjustments from your actual listening point while listening to reproduced sounds.

Output balance for the front speakers

Output level for the subwoofer

Once you adjust these items, the adjustments take effect for all the surround modes.

4To adjust the output level for the subwoofer

1) Press SOUND repeatedly to select

SOUND

“SW.”

 

Each time you press the button, the indication on the display changes as follows:

Before you start, remember...

There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 2 again.

00 F 00 00 R 00 CEN

Normal indication

 

SW

 

REAR

(canceled)

 

 

 

 

 

 

1Select and play any source except Dolby Digital or DTS Digital Surround.

2Cancel Dolby Surround or DSP modes if they are

activated.

For deactivating Dolby Surround:

PRO LOGIC

Press PRO LOGIC on the remote control until “STEREO” appears on the display.

For deactivating DSP modes:

DSP MODE

Press DSP MODE (or DSP on the front panel) until the DSP indicator goes off from the display.

Now, you are ready to start adjustments.

To adjust the output balance for the front speakers, go to the next step.

To adjust the output level for the subwoofer, go to step 4.

2) Press 3 or 2 to adjust the output level.

3: Increases the output level.

2 : Decreases the output level.

• The output level changes from –06 to +06.

• “SW –06dB” is the initial setting. If you have already changed the settings, another value will appear.

ENTER

20

Page 141
Image 141
JVC TH-A5 manual Creating Realistic Sound Fields