JVC TH-A5 manual Adjusting Dolby Surround

Creating Realistic Sound Fields

REW	FF
	VCR CHANNEL
	TUNING
B.SEARCH	F.SEARCH

2 3

ENTER

VOLUME

DVD	FM/AM	AUX	MUTING	AUX
1	2	3	SOUND	SOUND
			SETTING
4	5	6		PRO LOGIC
			PRO LOGIC
7	8	9
SLOW		SETUP	TEST
	0			DSP MODE

ANGLE ZOOM D.R.C DSP MODE

REPEAT A-B REPEAT PROGRAM EFFECT

CLEAR SEARCH REMAIN SLEEP

Adjusting Dolby Surround

You can adjust the following settings while activating Dolby Surround.

It is recommended that you make adjustments from your actual listening point while listening to reproduced sounds.

–Output balance for the front speakers

–Output balance for the rear speakers

–Output level for the rear speakers*

–Output level for the subwoofer

•When Dolby 3 Stereo is activated, you cannot adjust the rear speakers and subwoofer levels.

*The adjustment is separately memorized for Digital Multichannel Surround (Dolby Digital and DTS Digital Surround), and for Dolby Pro Logic.

•Dolby Surround cannot be used with DSP modes. Once one of Dolby Surround is activated, DSP modes in use will be canceled.

Before you start, remember...

3 Press PRO LOGIC repeatedly on the	PRO LOGIC
remote control to select Dolby Pro Logic
or Dolby 3 Stereo.

The PRO LOGIC indicator lights up on the display.

•Each time you press the button, the indication changes as follows:

PRO LOGIC 3 STEREO

STEREO

(canceled)

Now, you are ready to start adjustments.

•To adjust the output balance for the front speakers and the rear speakers, go to the next step.

•To adjust the output level for the center speaker, the rear speakers, and the subwoofer, go to step 5.

4To adjust the output balance for the front speakers and the rear speakers

1) Press SOUND repeatedly until one of	SOUND
the following adjustment indications
appears on the display.

•Each time you press the button, the indication on the display changes as follows:

00 F 00 00 R 00 CEN

Normal indication	SW	REAR
(canceled)

00 F (Front) 00 : To adjust the output balance for the front speakers.

00 R (Rear) 00 : To adjust the output balance for the rear speakers.

•When selecting “3 STEREO,” you cannot adjust the output balance for the rear speakers.

•“00 F 00” and “00 R 00” are the initial settings (the output balances are at the center position). If you have already changed the setting, another value will appear.

2) Press 3 or 2 to adjust the output balance.

• Make sure that you have set the speaker information correctly

(see page 16). You cannot adjust the speaker output balance

and levels when you have set the speaker settings to “NONE.”

3: Decreases the left speaker

output, or restores the right speaker output.

ENTER

• There is a time limit in doing the following steps. If the setting is

canceled before you finish, start from step 3 again.

1 Press AUX to select the	DVD FM/AM AUX MUTE
external component as
the source.

2Start playing a source encoded with Dolby Surround.

2 : Decreases the right speaker output, or restores the left speaker output.

•Each output balance changes from

OFF (silence), –06 (most reduction) to 00 (no reduction).

3)Repeat 1) and 2) for setting the other speakers.

22