JVC VN-C10 This section describes alarm setting, Alarm input is activated in the following cases

Preparations (Step 2 Setting the Network)

2-4 Other Settings with V.Networks Setup Tool [2. Alarm Setting]

This section describes alarm setting.

Alarm input is activated in the following cases.

¥Input signals are received from an input terminal located on the rear panel of the camera, [ALARM INPUT 1] or [ALARM INPUT 2]. (☞ Page 16)

¥Motion has been detected. (☞ Page 30)

Operation when alarm input is activated.

¥Output signals are sent from the output terminal located on the rear panel of the camera, [ALARM OUTPUT]. (☞ Page 17)

¥Alarm information is reported to [V.Networks Controller.] (☞ Page 29)

¥Alarm Images are recorded. (☞ Page 32)

1. Start up [V.Networks Setup Tool] and select [Alarm].

1 4

2
3
7	5
	6

8

2. When the setting is complete, select [Apply] and then .

28