JVC VN-C10 Default Page continued, Available/ Not available, File Name, HTTP Port, NTP Settings

6-4 Settings with a Web Browser (1. Other Settings) (continued)

	Item	Effect
Default Page (continued)
	Available/ Not available	Select [Available] to enable the Default Page function or [Not
		Available] to disable it.
	File Name	Enter the file name to be used as the default page.
HTTP Port		It is possible to enhance the security level by setting the HTTP
		server port number to other than the default value Ò80.Ó (Value
		range: (1 through 65535 excluding 21 and 554) The new HTTP
		port number can be accessed with a Web browser. If the port
		number is changed to, for example, Ò12345,Ó it can be accessed as
		http://192.168.0.2:12345 or http://192.168.0.2:12345/index-
		e.html. If the HTTP port number is unknown, refer to [V.Networks
		Setup Tool].
NTP Settings		For settings of the NTP (Network Time Protocol) server.
	Available/ Not available	Select [Available] to enable the NTP server function or [Not
		Available] to disable it.
	Server IP Address	Enter the NTP server IP address.
	Timezone	Obtains the local time based on the Greenwich Mean Time.
	Adjust Interval	Rectifies time deviation by acquiring the correct time from the
		NTP server at a specified interval.
	Note

•Password Protection Function

VN-C10 is equipped with a security function for restricting browser (user) access. For this function, there are three access (security) levels according to the authorization status. The table below shows the accessible pages for each status.

(For the VN-C10 Web page structure, refer to page 62.)

Authorization Status	Accessible VN-C10 Pages
User	Still image and moving image pages
Operator	Web pages except the setting pages
Administrator	All Web pages

Caution

●Password setting cannot be released or changed unless the administrator password is en- tered correctly. Do not forget the administrator password.

●Password entry is not required if the user and operator passwords are set, but not the one for the administrator. The confirmation message, ÒAre you sure to RESET the camera to enable the changes?Ó appears. Pressing [OK] for this message prompts VN-C10 to activate its internal reset function, changing the IP address, etc. The previous, factory-set, IP ad- dress is no longer in effect, and connection to VN-C10 will be cut off. If there is no keystroke or mouse movement to the Web browser for a while, a message saying that connection cannot be established appears. This is due to the IP address change. (Changing the port number results in the same action.)

67