Preparations (Step 2 Setting the Network)
This section describes the setting of the motion detection function which enables
(This function cannot be set for MPEG4.)
1. Start up [V.Networks Setup Tool]. Select [Alarm] and then enable [Motion Detection Alarm]. (☞Page 28 [Alarm Setting])
2. Select [Motion Detect] of [V.Networks Setup Tool].
Note
Select the desired monitoring area by click- ing and holding down the left button of the mouse and dragging it. The selected area is displayed in yellow.
Click the right button of the mouse and, while holding it down, drag the mouse to cancel a monitoring area.
The area in which motion has been detected is displayed in red.
The [Detail] button is used for more detailed settings.
●A selected area is only for reference. To ensure accuracy, perform operation check.
●One screen is divided in 300 (20x15) blocks. Adjust magnification of the lens so that the monitoring area (object) covers more than one block.
Caution
The motion detection function is not designed to prevent burglary or fire. It may not function properly depending on the condition of the object or settings described in this document. In no case, shall JVC be liable for any accidents and/or damage caused.
30