JVC VN-C10 Controls, Connectors and Indicators, Front, top and side views, 1Lens mount, 2 1 76

Controls, Connectors and Indicators

(Front, top and side views)

2

1 3

76

4

5

8

1Lens mount

The mount for attaching a lens. Either a C- mount or a CS-mount lens can be used.

2Back-focus adjustment ring

The ring for adjusting back-focus and chang- ing the mount method. For adjusting back-fo- cus or changing the mount method, loosen the back-focus locking screw (3) by turning it counterclockwise and, after the operation, fix it by turning it clockwise. At the factory, VN- C10 is optimized for attaching a CS mount lens.

3[BF LOCK] locking screw

This serves to fix the back focus-adjustment ring.

4Bracket for camera mounting.

At the factory, the bracket is attached on the bottom of the camera. According to the instal- lation condition, this can be attached at the top. Use the screws (7) for attaching the bracket to the camera.

5Screw hole (1/4-20UNC) For attaching the camera to

a fixer or a pan/tilt unit. The
screw length must not ex-
ceed 7 mm. If a longer screw	MAX.
is used, the internal parts of	7 mm
the camera may be dam-
aged.

6Fall-preventive holes

For installing the camera securely, use these holes to prevent it from falling off.

7Screws for the bracket (x 2: M2.6 X 6 mm) Screws of the length of 6 mm should be used. A longer screw may damage the internal parts.

8[MAC address]

Physical address unique to the unit. Cannot be changed.

9