JVC XL-R2010BK manual Programming Playback Using Main Unit Controls

Programming Playback Using Main Unit Controls

It is possible to select your own program (order of tracks being played) using the program playback mode. Any of the tracks (1-99) on the CD in the tray of the CD player can be selected.

If you want to program and record tracks, see “Program Edit Recording” on page 26.

14

XL-R2010 CD/CDR MULTIPLE COMPACT DISC RECORDER

STANDBY OPEN/CLOSE REC SOURCE OPEN/CLOSE

DIGITAL CD LINE MIC

								–	+
STANDBY/ON
	PLAY MODE	CD EDIT	CD REC	SYNCHRO	MENU	SET	CANCEL
LEVEL	PHONES						MIX BLANCE	LINE	CD
								MIC	LINE

STOP	PLAY	PAUSE	REC SOURCE	FINALIZE	STOP	PLAY	PAUSE REC/REC MUTING
			SELECTOR

MIN MAX	MIC
2 6	3,4

1 Load a CD into the tray of the CD player.

•Only tracks on the CD loaded in the CD player can be registered into the program (i.e., tracks on a CD loaded in the CDR cannot be selected for playback).

•“CD READ DISC” will be shown in the information display as the unit reads the information from each disc.

2 Press the PLAY MODE button when the unit is in the CD stop mode.

•The CD indicator is shown in the display window, PROG indi- cator is shown in the display window, and if no program has been registered, “PG NO PROGRAM” is shown in the informa- tion display.

•If SET is pressed at this time, programming registration will start (Step 3).

3 Press the SET button to start program registration.

•The information display will show the following, and disc source columns will flash.

Programming step number

Track number

4 Select and enter a track number (1-99) by turning the MULTI JOG control, and then press the SET button.

MULTI JOG / REC LEVEL SET

–+

1. Select the track. 2. Enter the selection.

•The following is an example of track 2 being entered as Step 1.

•When the SET button is pressed, the programming of Step 1 is registered, and programming for Step 2 is ready.

5 Repeat Step 4 to program up to a maximum of

32steps.

•If you try to program over 32 steps, “MEMORY FULL” is shown in the information display, and the programming func- tion ends automatically.

•Pressing the CD Control STOP 7 button on the main unit ends the programming function.

6 Press the CD Control PLAY 3 button to start programmed play.

•During playback, track number and play time of the track are shown in the information display.

•The numbers of the tracks that have been played are cleared from the music calendar. They are displayed again when pro- grammed play is completed.

•Operation stops automatically when all of the programmed tracks have been played.

•If the CD Control PLAY 3 button is pressed at a specific step in a program, the programming function will end and playback will start from Step 01, not the step currently shown in the infor- mation display.

To clear a step (track) from the program

To erase a programmed track, turn the MULTI JOG Control while in the CD stop mode until the track you want to erase is shown in the information display. Press the CANCEL button to erase the track from the program. The step number for each track following the one erased is automatically reduced by one (i.e., steps are renumbered). To erase the entire program, press the CANCEL but- ton until “PG NO PROGRAM” is shown in the information dis- play.

16