JVC XL-R5000BK manual Erasing all the tracks Disc Erase function

4 Press the SET button.

•“ERASE (start track) – (last track)” appears in the display. (Ini- tially, the start track and the last track are both the last track number recorded on the CD-RW.)

•Press the CANCEL button if you do not wish to perform this procedure.

5 If needed, use the MULTI JOG dial on the main unit or press the 4 and ¢ buttons on the remote control to set the number of tracks preceding the last track that you want to erase.

•Please note that all tracks following the start track will be erased. For example, when track 8 on an 11 track CD-RW is assigned as the start track, tracks 8, 9, 10, and 11 will be erased.

6 Press the SET button.

•After “ERASE TRACK” is displayed, the selected tracks are erased, and the normal display is returned to.

•The track to be erased is cleared from the music calendar.

•Tracks can only be erased from the end of the recording.

Notes

•Once a track is erased, the recording cannot be restored.

•Do not disconnect the power cord or subject the unit to the vibration during an erase operation. Doing so may make it impossible to play the CD-RW.

Erasing all the tracks (DISC ERASE function)

The DISC ERASE function clears all of the data recorded on a CD- RW.

Caution

If the disc is damaged or there is disc related trouble, this function may not be possible.

1
XL - R5000 CD/CDR MULTIPLE COMPACT DISC RECORDER	REC LEVEL
MIN		MAX
MIX BALANCE		PHONES LEVEL

		MULTI JOG
STANDBY
POWER	–	+
CANCEL	4,5 2

CD REC	SYNCHRO	DISPLAY POWER
CD EDIT	FINALIZE	MENU

				CD 1	2
	1	2	3
				CD 2
	4	5	6
				CD 3
	7	8	9
			CONTROL
	10	+10	CD	CDR
4,5	PLAY MODE REPEAT		SET	CANCEL	CANCEL
		PITCH +
		PITCH 0			3
2				REC
	SHIFT	PITCH –		REC MUTING

REMOTE CONTROL

RM-SXLR5000J

1 Load the unfinalized CD-RW to be edited, and

set the function to CDR.

• The number of tracks and play time are displayed.

2 When the unit is in the stop mode, press the MENU button on the main unit (or the DISPLAY/ MENU button on the remote control while holding down the SHIFT button).

3 Turn the MULTI JOG dial or press the 4/¢ button on the remote control until “DISC ERASE” appears in the display.

4 Press the SET button.

•“ERASE DISC?” appears in the display.

•Press the CANCEL button if you do not wish to perform this procedure.

5 Press the SET button.

•This procedure takes about one and a half minutes to perform. During the procedure, the length of the level meter is used to indicate approximately how much time is remaining until disc erasure is complete. When complete, the normal display is returned to.

28