2. Attaching the back board d

Allow the assembled pedal board and side panels to stand upright (vertically) on the floor.

Insert the back board dinto the grooves of the side panels.

From the front, secure the top of the back board to the side panels using the four short black screws g.

From behind, attach the bottom of the back board to the pedal board using the four long black tapping screws h.

d

g

b

It may be necessary to adjust the left and right side panels slightly in order to insert the back board smoothly into the grooves. Be careful not to damage the back board by applying too much force.

g

h h

h

h

3. Mounting the main body a

Ensure that two or more people undertake the following step of the assembly process.

Lift the main body aand carefully place it onto the stand.

Position the main body slightly towards the back of the stand, to ensure that the guide screw in the front of the stand is visible when viewed from above.

Gently slide the main body forward until it comes to a halt.

When lifting the main body onto the stand, be careful not to catch/trap hands and fingers.

Attach the main body to the stand from below using the two flat-tipped screws with the flat washer and spring washer e, then from behind using the two washers j and two long black screws f.

First, loosely attach all four screws, adjusting the position of the main body on the stand.

When all four screws are attached and the main body is correctly positioned on top of the stand, securely tighten all screws.

Tighten all screws securely to ensure that the main body is f irmly attached to the stand. Failing to do so may result in serious injury.

Lift onto stand, slide forward

Guide screw

ef+j

Appendix

91

Page 91
Image 91
Kawai CA93, CA63 manual Attaching the back board d, Mounting the main body a