6.1 Editing Procedure and Parameters
First, press the ZONE SELECT button for the zone to be edited.
Next, press the MENU buttons until the parameter you want to edit appears in the DISPLAY. When a zone is set as Both, pressing the ZONE SELECT button again will switch the menu list from Internal to External or vice versa.
Set the value of the parameter using the VALUE buttons.
Since each parameter has a different value range, consult the following pages for the details. Repeat this procedure for any other parameters in any of the zones that need to be modified.
Save these settings using the STORE button. (See page43 for detail)
Note:
Once you enter the edit mode from SETUP mode by pressing the MENU button, the mode automatically changes to SOUND mode and the SOUND SELECT buttons are used to select sounds, not SETUPs.
You can exit the edit mode by pressing the EXIT(SW) button. Any edits you have made so far will be retained to SOUND mode. If you exit the edit mode by pressing SOUND or SETUP buttons, your changes will be lost and the previously saved settings are recalled.
6.2 Edit Parameters
Zone parameters can be edited individually for each zone. There are two parameter groups, Internal parameter group and External parameter group. If a zone is set to Int, only Internal parameters are available for editing. If a zone is set to Ext, only External parameters are available for editing. If a zone is set to Both, both Internal and External parameters are available for editing.
6.2.1 Zone Mode
This parameter sets the Zone mode. The example shows that the Zone 1 is set to Both mode.
6.2.2 Sound (Int only)
This parameter determines which internal sound is assigned for the selected zone.
6.2.3 Damper Resonance (Int Piano only)
When the sustain pedal is depressed, the volume of the whole resonance can be changed to the level you prefer. The value changes from 0 (off) to 10.
* The display shows this parameter only when Piano sound is selected.
33
