SURFACE BURNERS
PROBLEM CAUSE/SOLUTION
The burner fails to light The control knob is not set correctly. Push in the control knobs before turning
them. Make sure the control knob is turned to the UTE position. (See p. 7.)
A household fuse has blown or a circuit breaker has been tripped,
The burner ports may be clogged. CLeanthem witha straight pin. (See p. 34.)
• Make sure Cooktop Lockout has been cancelled. (Seep. 13.)
There is a power outage. '
The burner flames are The burner ports may be clogged. Clean them with astraight pin. (See p. 34.)
uneven The burner caps may not be positioned properly. (See p. 34.)
The burner flames lift off The burner needs cleaning. (See pp. 33, 34.)
the ports, areyellow, or The burner may be damaged. Contact aSears Service Center to check
are noisy when turned off the burner.
• If propane gas isbeing used, the range may have been converted
improperly. Contact a Sears Service Center.
The burner makes a The burner is wet from washing. Let it dry.
popping noise when on i

WHEN SELF-CLEANING YOUR OVEN

PROBLEM CAUSE!SOLUTION
The Self-Cleaning cycle START/ENTER has not been pressed.
will not work Adelay start has been set. Wait for the start time to be reached or cancel
and reset the control.
The door is not closed all the way.
38