SEALED SURFACE BURNERS AND COOKTOP (contd.)
I".cleantheburners:o
1.Remove the burner cap from the burner base.
2, Clean the burner cap with warm, soapy water
and a sponge. You can also clean it with a mildly abrasive scrubbing pad or cleanser.
Do not clean the burner cap in a dishwasher or
3.If the gas tube opening has become soiled or clogged, use a damp cloth to clean the area.
4.ff the burner ports are clogged, clean them
fwith a straight pin. Do not enlarge or
distort the port. Do not use a wooden
toothpick. If the burner needs to be
adjusted, call a qualified technician for service.
5.After cleaning the gas tube opening and ports,
O | replace the burner |
cap. To replace the | |
burner cap, make | |
sure the alignment |
@properly aligned with the burner base.pins on the cap are
Gas tube opening
6.Turn on the burner to see if it will light. If the
after you have cleaned it, recheck cap alignment
or contact a Sears
i_burner does not light Service Center. Do not
service the sealed
burner yourself.
REMOVING THE OVEN DOOR
For normal use of your range, | you do | not | need to | Door removal | Door stop clip |
remove the door. However, if you find | it necessary | pin hole |
| ||
to remove the door, follow the | instructions | in this | _ |
| |
section. |
|
|
|
|
|
NOTE: The oven door is heavy.
Before removing the door:
1.Use a putty knife or screwdriver and insert it at the bottom corner of the door stop clip.
2.Pry door stop clip free and remove from front frame hinge slot. Take care not to scratch porcelain.
3.Repeat procedure for other door stop clip.
Hinge Front frame
hanger hinge slot
34
