Kenmore 665.95829, 665.95822, 665.95824 manual REMOVING THE OVEN DOOR contd, The Oven Light

REMOVING THE OVEN DOOR (contd.)

2.Hold oven door so that the top edge of each hinge hanger is horizontal. Insert hinge hangers into the front frame hinge slots.

3.Tilt top of door toward range. Slide hinge hangers down onto front frame support pins.

NOTE: Make sure the hinge hangers are fully seated and engaged on the support pins.

4.Insert the door stop clip with the angular surface at the top of the frame hinge slot, then push in the bottom of the clip until flanges are flush with the front frame.

5.Open the door completely and remove the door

removal pins. Save door removal pins for future

use.

6.Close the door.

7.Check for alignment to make sure door is installed evenly.

Door stop	Range
clip
Door removal			Hinge
pin hole	,_ _	.......	hanger
O		Support		pins
l _Front			frame
_lfll	III
		hinge	slot
	J	Angular
	.......	surface		of

door stop clip

THE OVEN LIGHT

The oven light will come on when you open the oven door. The oven light will not work during the Self-Cleaning cycle.

• Press the OVEN pad. ,,,,cC)

1.Unplug range or disconnect power.

2.Remove the glass bulb cover in the back of the

oven by turning it counterclockwise.

4. Replace the light bulb cover by turning it clockwise.

3.Remove the light bulb from its socket by turning it counterclockwise. Replace the bulb with a 40-watt appliance bulb.

5. Plug in range or reconnect power.

44