THE CONSOLE NIGHT LIGHT

The console night light is located on the top of the control panel. It has two replaceable parts. The fluorescent light is a standard F8T5 miniature fluorescent lamp. The starter is the knob-shaped part to the left of the light. It is a standard FS-5C starter. The console night light will not work during the Self-Cleaning cycle.

• Press the TOP pad momentarily.

qrlJ{_

1. Unplug range or disconnect power.

1.Fit starter prongs into starter mounting base and turn clockwise.

2.Slide bulb prongs into bulb mounting base ends. Roll the bulb forward or backward 90° until you hear a click.

2.From the front of the range, push back on lens and lift lens out.

3.Push release lever toward the bulb. The left end of the light assembly wilt raise up.

ReleaseBulb

Lever

Starter _ j__

3.Push down on the left bulb mounting base. You

will hear a click indicating the assembly has latched.

4.Replace the lens cover. Position the two rear lens cover tabs in front of the two metal spring clips, located directly behind the bulb. Push back and down on the lens to lock lens into position.

5.Plug in range or reconnect power.

4.To remove the starter, turn it counterclockwise and lift out of its mounting base.

5.To remove the bulb, roll it forward or backward 90° until you hear a click, then lift out.

45

Page 45
Image 45
Kenmore 665.95822, 665.95824, 665.95829 manual Console Night Light, ReleaseBulb Lever Starter j