Kenmore W10026626B manual Plug into a grounded 3 prong outlet

4= Check the levelness of the washer by placing a level in the crease between the top of the washer and the cabinet, first on the front and then on the side.

Level the front.

Level the side.

5.If the washer is not level, move the washer out slightly, tip back, prop up the front of the washer on a wood block. Adjust the feet up or down as necessary by twisting the feet. Repeat steps 1 through 4 until washer is level.

6.Use a g/le" or 14 mm open-end wrench to turn the Iocknut counterclockwise on the foot tightly against the washer cabinet.

IMPORTANT: If the Iocknut is not tight against the washer cabinet, the washer may vibrate.

1.Check the electrical requirements. Be sure that you have the correct electrical supply and the recommended grounding method. See "Electrical Requirements."

2.Check that all parts are now installed. If there is an extra part, go back through the steps to see which step was skipped.

3.Check that you have all of your tools.

4.Keep the foam packing ring from the washer tub for future relocation of the washer. Dispose of/recycle all packaging materials.

5.Check that the water faucets are on.

6.Check for leaks around faucets and inlet hoses.

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death, fire, or electrical shock.

7= Plug into a grounded 3 prong outlet.

8.Remove any protective film or tape remaining on the washer.

9.Read "Washer Use."

10.To test and to clean your washer, measure 1/2of the detergent manufacturer's recommended amount of High Efficiency (HE) powdered or liquid detergent for a medium-size load and pour it into the detergent dispenser. Close the lid. Press POWER. Select a normal cycle and press Start. Allow it to complete one whole cycle.

10