Kenmore W10026626B manual Floor drain, Connect the inlet hoses to the water faucets

Laundry tub drain or standpipe drain

Connecting the drain hose form to the corrugated drain hose

A

S

4.5"

(11.4 cm)

±

A. Drain hose reliefs

1.Feed end of drain hose into one end of form. Place end of drain hose form into the drain hose relief.

2.Bend the hose over the top of the form and feed into the other end of the form. Attach the other end of the form into the other drain

hose relief. The hose must extend 4V2" (11.4 cm) beyond the form.

To keep drain water from going back into the washer:

•Do not force excess drain hose into standpipe. Hose should be secure but loose enough to provide a gap for air.

•Do not lay excess hose on the bottom of the laundry tub.

4.Using pliers, tighten the couplings with an additional two-thirds turn.

Tighten the couplings with an additional two-thirds turn.

NOTE: Do not overtighten or use tape or sealants on the valve. Damage to the valves can result.

Clear the water lines

•Run water through both faucets and inlet hoses, into a laundry tub, drainpipe or bucket, to get rid of particles in the water lines that might clog the inlet valve screens.

•Check the temperature of the water to make sure that the hot water hose is connected to the hot water faucet and that the

cold water hose is connected to the cold water faucet.

Floor drain

Do not install the drain hose form on to the corrugated drain

hose. You may need additional parts. See Floor drain under "Tools and Parts."

1, Insert new flat washers (supplied) into each end of the inlet hoses. Firmly seat the washers in the couplings.

AB

A.Coupling

B.Washer

Connect the inlet hoses to the water faucets

Make sure the washer basket is empty.

2.Attach the hose labeled hot to the hot water faucet. Screw on coupling by hand until it is seated on the washer.

3.Attach the hose labeled cold to the cold water faucet. Screw on coupling by hand until it is seated on the washer.

Connect the inlet hoses to the washer

AB

COLD

A. Hot water inlet valve

B. Cold water inlet valve

1.Attach the hot water hose to the inlet valve labeled hot.

2.Attaching one hose coupling first makes it easier to tighten the connection with pliers.

3.Screw on coupling by hand until it is seated on the washer.

8