Scanning the Channels
You can scan the transceiver channels to search for a signal. When the transceiver verifies a signal on a channel, it proceeds to check whether or not its QT/ DQT setting matches that which is set up on your transceiver (if you have set a channel with QT/ DQT). If the QT/ DQT matches, the transceiver stops at the channel and opens the squelch so you can listen to the call. If the QT/ DQT does not match, the call is ignored and scanning continues.
Before you can use the scan function, ensure that it is activated. You can turn the scan function (the ability to perform scan) ON or OFF in Setting mode.
1With the transceiver power OFF, press and hold the MENU key while turning the transceiver power ON (for 1 second).
2Press the 
or 
key to select “ 
”.
3Press the MENU key then press 
or 
to select “ 
” (scan function disabled) or “ 
” (scan function enabled).
•If you select “ 
”, you will no longer be able to perform scan by pressing and holding the 
key {page 18}.
4Press the MENU key to exit the selection.
5Press the PTT, MON, or CAL key to exit Setting Mode.
17
