Incoming Call Notification
Note: To use Incoming Call Notification, you must set up a QT tone or a DQT code {page 16}.
Incoming Call Notification is used to inform you of when a call is being received. When activated, a tone is emitted when a busy signal is received and the QT/ DQT signaling matches.
•The tone will sound for 15 seconds before turning off.
•While the tone sounds, you will not hear any audio from the speaker. Press any key to turn the tone off and listen to the received call.
After the call is finished, the transceiver will wait for 10 seconds before resetting. If you receive a new call within those 10 seconds, the tone will not sound. If no call is received within 10 seconds, Incoming Call Notification will reset so that the next time a call is received, the tone will sound again.
To turn Incoming Call Notification on or off:
1With the transceiver power OFF, press and hold the MENU key while turning the transceiver power ON (for 1 second).
2Press the 
or 
key to select “ 
”.
3Press the MENU key then press 
or 
to select “ 
”
(incoming call notification off), or “ 
” (incoming call notification on).
4Press the MENU key to exit the selection.
5Press the PTT, MON, or CAL key to exit Setting Mode.
40
