15
3
BASIC TRANSCEIVER MODES
This section introduces you to the basic modes you can
select.

VFO mode

Press [VFO] to select. You can change the operating
frequency using the Tuning control or Mic [UP]/ [DWN].

Memory Recall mode

Press [MR] to select. You can change memory
channels, using the Tuning control or Mic [UP]/ [DWN],
where you stored frequencies and related data. Refer to
“MEMORY CHANNELS” {page 35}.

Programmable Memory (PM) mode

Press [PM] to select. You can select the transceiver
environment, by pressing [1] to
[5], that you stored in
PM channels. Refer to “PROGRAMMABLE MEMORY
(PM)” {page 42}.

Menu mode

Press [MNU] to select. You can change Menu Nos.
using the Tuning control or [cc
cc
c]/ [dd
dd
d]. Refer to “MENU
SET-UP” {page 22}.

APRS mode/ Packet mode

Press [F] (1 s), [TNC] to select APRS mode. Press [F] (1 s),
[TNC] again to select Packet mode. In APRS mode, you
can receive and transmit APRS packets. In Packet mode,
you can send commands to the built-in TNC from a personal
computer. Refer to the separate manual, “SPECIALIZED
COMMUNICATIONS” {pages 4 and 11}.
1
2
1
2
APRS mode Packet mode