Kenwood Comprehensive Guide to TM-D700 Manual Instructions

■Locking Out a Memory Channel

Select memory channels that you prefer not to monitor while scanning.

1 Recall the desired memory channel.

2 Press [MNU] to enter Menu mode.

3 Press [c]/ [d] to select “RADIO (1–)”, then press [OK].

4 Press [c]/ [d] to select “MEMORY (1–4–)”, then press [OK].

5 Press [c]/ [d] to select “LOCKOUT (1–4–3)”, then press [OK].

6Press [c]/ [d] to switch Lockout ON (or OFF).

7Press [OK] to complete the setting.

8Press [MNU] to exit Menu mode.

•A star appears to indicate the channel has been locked out.

Note: The L0 to L9 and U0 to U9 memory channels cannot be locked out.

GROUP SCAN

For the purpose of Group Scan, the 200 memory channels are divided into 10 groups, with each group containing 20 channels. Group Scan monitors only the 20 channels which belong to the specified group. The channels are grouped as below:

Nos. 1 ~ 20	Nos. 101 ~ 120
Nos. 21 ~ 40	Nos. 121 ~ 140
Nos. 41 ~ 60	Nos. 141 ~ 160
Nos. 61 ~ 80	Nos. 161 ~ 180	9
Nos. 81 ~ 100	Nos. 181 ~ 200

1Recall one of the memory channels in the desired group.

2Press [MHz] (Tuning control) (1 s).

•Scan starts with the channel last recalled.

•The 1 MHz decimal blinks while scanning is in progress.

•To reverse the scan direction, turn the Tuning control clockwise (upward scan) or counterclockwise (downward scan). You can also press Mic [UP]/ [DWN].

3To quit Group Scan, press [MHz] again.

Note:

◆At least 2 or more memory channels in the specified group must contain data and must not be locked out.

◆You can also start Group Scan when in Channel Display mode. While Scan is being interrupted, the channel number blinks.

51