Kenwood TM-D700 E instruction manual POWER-ON Message, Display Demonstration

POWER-ON MESSAGE

Each time you switch the transceiver ON, “HELLO !!” appears and stays for approximately 2 seconds. You can program your favorite message in place of the factory default.

1Press [MNU] to enter Menu mode.

2Select Menu 1–1–1 (POWER-ON MSG), then press [OK].

•The display for entering a message appears; the first digit blinks.

3Turn the Tuning control to select a character.

•You can enter alphanumeric characters plus special ASCII characters.

4Press [a].

•The cursor moves to the next digit.

5Repeat steps 3 and 4 to enter up to 8 digits.

Switches among the sets of alphanumeric characters, accented letters (TM-D700E only), and special ASCII characters.

Switches between	Cancels Message
small and capital	Entry.
letters.
Deletes the digit at	Causes the cursor
which the cursor is	to move backward.
blinking.

Inserts the currently			Clears all digits and
selected character. (left		BAND backs the cursor to
	SEL)		the first digit.

6Press [OK] to complete the setting.

7Press [MNU] to exit Menu mode.

The keypad on the MC-53DM also is available to enter alphanumeric characters in step 3. See page 18.

DISPLAY DEMONSTRATION

By initiating this function, various preprogrammed

displays appear. You still can normally use the14 transceiver in this mode. Pressing a front panel button

or Mic key, or turning the Tuning control restores the operating display immediately. If there is no button/key entry or Tuning control adjustment for approximately 10 seconds, the transceiver reverts back to Demonstration mode.

Press [F]+ POWER ON to switch the function ON (or OFF).

71