Kenwood VC-H1 Connection with a Handy Transceiver, REMOVING/ Reinstalling the Camera Unit

CONNECTION WITH A HANDY TRANSCEIVER

Use the provided cable to connect the VC-H1 with a handy transceiver.

Note: The VC-H1 functions as a speaker microphone only when connected with a handy transceiver. You need not switch ON the VC-H1.

1Confirm that the power switches of both the VC-H1 and transceiver are OFF.

2Connect the appropriate end of the provided cable to the DATA port of the VC-H1.

• To remove the cable from the VC-H1, pull the cable

connector downward while pushing its tabs from both sides.

To remove

3Connect the other end of the cable to the speaker/ microphone jacks on your handy transceiver.

Note: The compatible handy transceivers are TH-26, TH-46, TH-27, TH-47, TH-28, TH-48, TH-22, TH-42, TH-77, TH-78, TH-79, and TH-G71. An optional PG-4T cable is available for connecting with a TM-255, TM-455, TM-733, TM-V7, or TM-G707 transceiver. To make a cable for connecting with a TS-570 or TS-870 transceiver, you may obtain an optional connector kit (E59-0407-08) which mates with the VC-H1 DATA port. For the above options, contact your authorized KENWOOD dealer, customer service, or service center.

REMOVING/ REINSTALLING THE CAMERA UNIT

Note: Turn OFF the power to the VC-H1 before removing or reinstalling the camera unit.

To remove the camera unit, first turn it so that it crosses at right angles with the main unit.

or

To reinstall the camera unit, first position the port on the camera unit over the port on the main unit so that the two units cross at right angles.

Note: The camera unit has a structure that allows the plug assembly to be slightly moved. This is aimed at absorbing stress to be caused when the camera unit is turned.

5