How the Cycle Works
IMPORTANT: The heating and cooling of porcelain on steel in the oven may result in discoloring, loss of gloss, hairline cracks and popping sounds.
The
The oven is preset for a 3 hour 30 minute clean cycle.
Once the oven has completely cooled, remove ash with a damp cloth. Do not wipe down any of the inside surfaces until the oven has completely cooled down. Applying a cool damp cloth to the inner door glass before it has cooled completely could result in the glass breaking.
The oven light will not work during the
To Self-Clean:
Before
1.Turn the SELECTOR knob to CLEAN.
2.Turn the SET knob to “On.”
3.Press the ENTER button to start a preset
REMEMBER: On double oven models only, when one oven cavity is in
To Delay Start Self-Clean:
Before delay starting
1.Turn the SELECTOR knob to CLEAN.
2.Turn the SET knob to “On.”
3.Press the ENTER button to start a preset
4.Press the ENTER button twice.
The time the cycle will end is displayed and the STOP TIME LED will blink.
5.Turn the SET knob to STOP TIME.
6.Press the ENTER button.
The DURATION and STOP TIME arrow will glow.
To Stop Self-Clean anytime:
Turn the SELECTOR knob to the RESET position or press the CANCEL button. If the oven temperature is too high, the door will remain locked. It will not unlock until the oven cools.
GeneralCleaning
IMPORTANT: Before cleaning, make sure all controls are off and the oven and cooktop are cool. Always follow label instructions on cleaning products.
Soap, water and a soft cloth or sponge are suggested first unless otherwise noted.
STAINLESS STEEL
Do not use
Rub in direction of grain to avoid damaging.
Cleaning Method:
■KitchenAid® Stainless Steel Cleaner & Polish Part Number 4396920 (not included)
See “Assistance or Service” section to order.
■Liquid detergent or
Rinse with clean water and dry with soft,
■Vinegar for hard water spots
PORCELAIN-COATED GRATES AND CAPS
Food spills containing acids, such as vinegar and tomato, should be cleaned as soon as the cooktop, grates and caps are cool. These spills may affect the finish.
To avoid chipping, do not bang grates and caps against each other or hard surfaces such as cast iron cookware.
Do not reassemble caps on burners while wet.
Do not clean in the
Do not clean in dishwasher.
Cleaning Method:
■Nonabrasive plastic scrubbing pad and mildly abrasive cleanser:
Clean as soon as cooktop, grates and caps are cool.
SURFACE BURNERS
Sealed Burner models
See “Sealed Surface Burners” section.
COOKTOP CONTROLS
Do not use steel wool, abrasive cleansers or oven cleaner.
Do not soak knobs.
When replacing knobs, make sure knobs are in the OFF position.
On some models, do not remove seals under knobs.
NOTE: When replacing knobs after cleaning either the surface burner controls or the grill module control, make sure the knobs are replaced to the correct location. For example, the knobs for the surface burner controls will read “LITE,” while the knob for the grill will read “LITE/HI.”
Cleaning Method:
■Soap and water or dishwasher:
Pull knobs straight away from control panel to remove.
EXTERIOR PORCELAIN ENAMEL SURFACES
Food spills containing acids, such as vinegar and tomato, should be cleaned as soon as the entire appliance is cool. These spills may affect the finish.
Cleaning Method:
■Glass cleaner, mild liquid cleaner or nonabrasive scrubbing pad:
Gently clean around the model and serial number plate because scrubbing may remove numbers.
CONTROL PANEL
Do not use abrasive cleaners,
Cleaning Method:
■Soap and water.
Wash, rinse and dry with a soft cloth.
■Glass cleaner and soft cloth or sponge:
Apply glass cleaner to soft cloth or sponge, not directly on panel.
21
