Oven Lights
The oven lights are
To Replace:
Before replacing, make sure the oven is off and cool.
1.Disconnect power.
2.Remove glass light cover by grasping the front edge and pulling away from oven.
3.Remove bulb from socket.
4.Replace bulb, using tissue or wearing cotton gloves to handle bulb. Do not touch bulb with bare fingers.
5.Replace bulb cover by snapping back into wall.
6.Reconnect power.
Oven Door
For normal range use, it is not suggested to remove the oven door. However, if removal is necessary, make sure the oven is off and cool. Then, follow these instructions. The oven door is heavy.
To Remove:
1.Open oven door all the way.
2.Flip up the hinge latch on each side.
3.Close the oven door as far as it will shut.
4.Lift the oven door while holding both sides.
Continue to push the oven door closed and pull it away from the oven door frame.
To Replace:
1.Insert both hanger arms into the door.
2.Open the oven door.
You should hear a “click” as the door is set into place.
3.Move the hinge levers back to the locked position. Check that the door is free to open and close. If it is not, repeat the removal and installation procedures.
TROUBLESHOOTING
Try the solutions suggested here first in order to avoid the cost of an unnecessary service call.
Nothing will operate
■Has a household fuse blown, or has a circuit breaker tripped?
Replace the fuse or reset the circuit breaker. If the problem continues, call an electrician.
Surface burners will not operate
■Is this the first time the surface burners have been used? Turn on any one of the surface burner knobs to release air from the gas lines.
■Is the control knob set correctly? Push in knob before turning to a setting.
■Are the burner ports clogged?
On sealed burner models, see “Sealed Surface Burners” section.
Surface burner flames are uneven, yellow and/or noisy
■Are the burner ports clogged?
On sealed burner models, see “Sealed Surface Burners” section.
■On models with caps, are the burner caps positioned properly?
See “Sealed Surface Burners” section.
■Is propane gas being used?
The appliance may have been converted improperly. Contact a trained repair specialist.
23