Allied Telesis AT-WA7500 manual General Troubleshooting, Problem/Question Possible Solution/Answer

Chapter 8: Managing, Troubleshooting, and Upgrading Access Points

Table 69. MobileLAN access LED Boot Sequence for Release 2.2 (or later) (Continued)

(Wireless #1 and #2 blink in unison.)

Only Boot ROM code is available on access point. Load new files.

LED On LED Off LED Flashing

After the AT-WA7500 or AT-WA7501 successfully boots, the LEDs display one of these patterns:

Table 70. AT-WA7500 and AT-WA7501 Normal LED Pattern After Booting

General Troubleshooting

(Blinks for	(Blinks if a	(Blinks for	(Blinks if the
wireless	radio is	wired data	AP
data traffic.)	installed.)	traffic.)	becomes
			root.)

Table 71. General Troubleshooting

Problem/Question	Possible Solution/Answer
The Wireless #1, Wireless	An error occurred during the booting
#2, and/or Wired LAN	process. Consult the previous section to
LEDs are on solid at the	determine which test failed.
end of the boot process.	Connect the access point to a PC with an
	RS-232 cable, reboot the access point,
	and watch the error messages.
	The access point may have a hardware
	problem. Contact Allied Telesyn Technical
	Support.

246