Allied Telesis AT-WA7501, AT-WA7500 manual ˆ DIX ARP ˆ Icmp

AT-WA7500 and AT-WA7501 Installation and User’s Guide

2.Make sure that the root access point and the access point at the endpoint of the IP tunnel have the same LAN ID.

3.On the root access point, set the Mode parameter to Originate if Root. For help configuring a root access point, see “About the Primary LAN and the Root Access Point” on page 131.

4.On the access point at the endpoint of the IP tunnel, set the Mode parameter to Listen.

5.On the root access point, click IP Tunnels > IP Addresses. Enter the IP address or DNS name of the access point at the endpoint of the IP tunnel.

6.On the root access point and the access point at the endpoint of the IP tunnel, click Frame Type Filters. If you have end devices communicating using IP, set these DIX filters to Pass:

ˆDIX-IP-TCP Ports

ˆDIX-IP-UDP Ports

ˆDIX-IP-Other Protocols

ˆDIX-IPX Sockets

ˆDIX-Other EtherTypes

7.On the root access point and the access point at the endpoint of the IP tunnel, click Predefined Subtype Filters.

If you have end devices communicating using IP, set these filters to Pass:

ˆDIX ARP

ˆICMP

8.Click Submit Changes to save your changes. To activate your changes, from the menu bar click Save/Discard Changes, and then click Save Changes and Reboot. For help, see “Saving Configuration Changes” on page 46.

143