AT-WA7500 and AT-WA7501 Installation and User’s Guide

Table 71. General Troubleshooting (Continued)

 

 

Problem/Question

Possible Solution/Answer

 

 

 

 

The Power LED is not on.

1.Make sure the power cable is firmly

 

plugged into the AT-WA7501 access point

 

and the power source. Or make sure the

 

Ethernet cable is firmly plugged into the

 

AT-WA7500 access point and the power

 

over Ethernet bridge.

 

2.Verify that the power injector has power

 

and will work with another access point at

 

the port in question.

 

3.Make sure all eight wires in the Ethernet

 

cable are connected, or the power over

 

Ethernet option won’t work.

 

4.Unplug the access point, and then plug

 

it back into the power source. After the

 

access point boots, verify that the Power

 

LED remains on.

 

5.The access point may have a hardware

 

problem. Contact Allied Telesyn Technical

 

Support.

 

 

You cannot connect to the

1.Verify that you are using a null-modem

access point using the

cable to connect the access point to your

serial port.

terminal or PC.

 

2.Verify that you are communicating

 

through the correct serial port.

 

3.Verify that your terminal or PC is set to

 

9600, N, 8, 1, no flow control. (Verify that

 

the baud rate is not 115200.)

 

4.Your system may be in autobaud mode.

 

Reboot and press a key once per second

 

until the sign on screen appears.

 

 

247

Page 247
Image 247
Allied Telesis AT-WA7501, AT-WA7500 manual 247