Allied Telesis AT-WA7501, AT-WA7500 manual 243

AT-WA7500 and AT-WA7501 Installation and User’s Guide

Table 68. Alphabetized List of Configuration Error Messages (Continued)

Configuration Error Message	Additional Information
The access point is set to originate IP	On the IP Tunnels screen,
tunnels but no there are no tunnel IP	Mode is set to Originate if
addresses.	Root, but no IP addresses
	have been added to the IP
	Addresses screen. Either
	change the mode or add
	some addresses. For help,
	see “Configuring IP
	Tunnels” on page 148 and
	“Configuring the IP
	Address List” on page 149.
The address range for the DHCP server is	On the TCP/IP Settings >
invalid.	DHCP Server Setup
	screen, the Low Address
	and High Address are not
	set correctly. For help, see
	the Table 16, ”DHCP
	Server Setup Parameter
	Descriptions” on page 73.
The DHCP server is enabled with an	On the TCP/IP Settings >
address range that is too large. If saved,	DHCP Server Setup
the range will be truncated to the	screen, the Low Address
maximum number of addresses.	and High Address are not
	set correctly. For help, see
	the Table 16, ”DHCP
	Server Setup Parameter
	Descriptions” on page 73.
The DHCP server requires a non-zero IP	For help, see “Configuring
address.	the Access Point as a
	DHCP Server” on page 70.
The DHCP server subnet mask is invalid.	For help, see the Table 16,
	”DHCP Server Setup
	Parameter Descriptions”
	on page 73.
The IAPP secret key has not been	Allied Telesyn
changed from its default value.	recommends that you
	change the IAPP secret
	key from the default for
	security reasons.
The IP Address is zero.	For help, see “Configuring
	the TCP/IP Settings” on
	page 65.

243