Allied Telesis AT-WA7500, AT-WA7501 manual Parameter Explanation

Chapter 3: Configuring the Ethernet Network

4.If you want to configure the access point as a NAT server, see “About Network Address Translation (NAT)” on page 75.

5.If you want to configure the access point to send ARP requests, see “Configuring the Access Point to Send ARP Requests” on page 76.

6.Click Submit Changes to save your changes. To activate your changes, from the menu bar click Save/Discard Changes, and then click Save Changes and Reboot. For help, see “Saving Configuration Changes” on page 46.

	Table 13. TCP/IP Settings Descriptions
Parameter		Explanation
IP Address		Enter the IP address of the access point. The IP
		address has the form x.x.x.x, where x is a number
		from 0 to 255.
IP Subnet Mask		Enter the subnet mask that matches the other
		devices in your network. The subnet mask has
		the form x.x.x.x, where x is a number from 0 to
		255.
		If you use DHCP to obtain an IP address for this
		access point, the subnet mask that is obtained
		from DHCP will supersede this one.
IP Router		Enter the IP address of the router that will forward
(Gateway)		frames if the access point will communicate with
		devices on another subnet. The IP address has
		the form x.x.x.x, where x is a number from 0 to
		255.
DNS Address 1		Enter the IP address of a domain name server
		that the access point uses to resolve DNS
		names. If this access point is a DHCP server, this
		DNS address will be distributed to DHCP clients.
		You can enter up to two DNS addresses to be
		delivered to DHCP clients.
DNS Address 2		Enter the IP address of a domain name server
		that the access point uses to resolve DNS names
		if the DNS server at DNS Address 1 is not
		responding. If this access point is a DHCP server,
		this DNS address will be distributed to DHCP
		clients.

66