KitchenAid KFGR274, KFGR382, KFGR292 For models with side burners, Natural Gas Use, Fire Hazard

Installation Instructions — Built-In Outdoor Grill (non-combustible construction)

WARNING

Fire Hazard

Do not install this grill on or near combustible materials.

Doing so can result in death or fire.

IMPORTANT: If grill is to be installed in a combustible enclosure, return this unit and replace it with the model which is manufactured for use in a combustible enclosure.

WARNING

Fire Hazard

Do not use grill near combustible materials.

Do not store combustible materials near grill.

Doing so can result in death or fire.

WARNING

Excessive Weight Hazard

Use two or more people to move and install grill.

Failure to do so can result in back or other injury.

Natural Gas Use

This installation must conform with local codes and ordinances**. In the absence of local codes, installations must conform with either the National Fuel Gas Code ANSI Z223.1, or CAN/CGA-B149.1* Natural Gas and Propane installation code.

1. Place grill into outdoor enclosure, but leave enough room in back to connect to gas supply.

WARNING

Explosion Hazard

Securely tighten all gas connections.

If connected to LP, have a qualified person make sure gas pressure does not exceed 11” (28 cm) water column.

Examples of a qualified person include:

licensed heating personnel, authorized gas company personnel, and,

authorized service personnel.

Failure to do so can result in death, explosion, or fire.

2. Make gas connections.

A combination of pipe fittings must be used to connect the grill to the existing gas line.

•If local codes permit, use an outdoor flexible stainless steel tubing gas connector, design-certified by AGA or CSA International, to connect the grill to the rigid gas supply line. 5/8" diameter line is recommended. Using a wrench to tighten, connect the gas supply to the grill. Use pipe joint compound on all non- flared male threads. Do not kink or damage the flexible connector when moving the grill.

•Pipe-joint compounds suitable for use with L.P. gas must be used. Do not use Teflon® tape.

1/2" grill

rear of gas pipe grill

flexible gas connector

Copies of the standards listed may be obtained from:

*CSA International

8501 East Pleasant Valley Rd. Cleveland, Ohio 44131-5575

**for local codes, contact your local building inspector

3. Open shutoff valve in the gas supply line. The valve is open when the handle is parallel to the gas pipe.

valve open

valve closed

4. Test all connections by brushing on an approved non-corrosive leak- detection solution. Bubbles will show a leak. Correct any leak found.

5. Open the hood.

6. For models equipped with rotisserie, remove the rotisserie’s skewer from the grill.

7. For models with side burners.

Remove side burner cover from the top of the carton that is located on the grill grate. Remove bubble wrap from side burner cover and set aside.

Open carton located on the grill grate. Remove side burner grate, unwrap and set aside.

Remove burners and burner caps from carton and unwrap. Install each set of burners and caps inside the side burner cavity as shown.

notch

burner

cap

burner

	alignment
	tab
Install side
burner grate	cover
and cover	extension
(with extension
toward grill)	burner
as shown.
	grate
Properly dispose
of all packing
material.

®T eflon is a registered trademark of E.I. Du Pont de Nemours and Company.

9