KitchenAid KFGR382, KFGR274, KFGR292, KFGR364, KFGR270 If converted to Natural Gas, Natural Gas Use

If converted to Natural Gas

Natural Gas Use

This installation must conform with local codes and ordinances**. In the absence of local codes, installations must conform with either the National Fuel Gas Code ANSI Z223.1, or CAN/CGA-B149.1* Natural Gas and Propane installation code.

WARNING

Explosion Hazard

Use a new AGA or CSA approved “outdoor” gas supply line.

Securely tighten all gas connections.

Failure to do so can result in death, explosion, or fire.

1. Make gas connections.

A combination of pipe fittings must be used to connect the grill to the existing gas line.

•If local codes permit, use an outdoor flexible stainless steel tubing gas connector, design-certified by AGA or CSA International, to connect the grill to the rigid gas supply line. 5/8" diameter line is recommended. Using a wrench to tighten, connect the gas supply to the grill. Use pipe joint compound on all non- flared male threads. Do not kink or damage the flexible connector when moving the grill.

•Pipe-joint compounds suitable for use with L.P. gas must be used. Do not use Teflon® tape.

1/2" grill

rear of gas pipe grill

flexible gas connector

8

2. Open shutoff valve in the gas supply line. The valve is open when the handle is parallel to the gas pipe.

Test all connections by brushing on an approved non-corrosive leak-detection solution. Bubbles will show a leak. Correct any leak found.

valve open

valve closed

Copies of the standards listed may be obtained from:

*CSA International

8501 East Pleasant Valley Rd. Cleveland, Ohio 44131-5575

**for local codes, contact your local building inspector

®T eflon is a registered trademark of E.I. Du Pont de Nemours and Company.