| Code | Operator Message Displayed | Description/Action Required | |
|
|
|
|
|
| E283 | Invalid configuration for OCR | OCR is not enabled in the mode selected. | |
|
|
| Enable the OCR using function code F76, or | |
|
|
| change the application mode to one in which the | |
|
|
| OCR is enabled. | |
|
|
|
|
|
| E284 | OCR initializing - please wait | System is busy. | |
|
|
| Wait until the message clears and continue. | |
|
|
|
|
|
| E285 | Feeder off due to OCR request | System is busy. | |
|
|
| Feeder will be reactivated when the system is no | |
|
|
| longer busy. | |
|
|
| Wait until the message clears and continue. | |
|
|
|
|
|
| E286 | Feed calibration target | Calibration process has started. | |
|
|
| Press the Run key and feed the calibration target | |
|
|
| into the transport. | |
|
|
|
|
|
| E288 | OCR batch stopped due to error | Determine the cause of the error via the OCR | |
|
|
| Workstation interface. | |
|
|
| Correct the error. Rerun the batch. | |
|
|
|
|
|
| E291 | Scanner disabled | The machine has been disabled due to an error. | |
|
|
| Determine the cause of the error via the host | |
|
|
| system. | |
|
|
| Enable the machine. | |
|
|
| Press the Run key to continue. | |
|
|
|
|
|
| E293 | Host recovery required | Contact your System Administrator to initiate the | |
|
|
| required action on the host system. | |
|
|
|
|
|
| E294 | Front calibration warning | Perform maintenance/cleaning procedures for the | |
|
|
| Document Scanning Array, Image Guides, etc. | |
|
|
| Check the lamps; replace if necessary. | |
|
|
| Recalibrate the machine. | |
|
|
|
|
|
| E295 | Rear calibration warning | Perform maintenance/cleaning procedures for the | |
|
|
| Document Scanning Array, Image Guides, etc. | |
|
|
| Check the lamps; replace if necessary. | |
|
|
| Recalibrate the machine. | |
|
|
|
|
|
| E296 | Target not seen | Repeat the calibration process using a blank target. | |
|
|
| If error repeats, call service. | |
|
|
|
|
|
| E297 | Document que full | The feeder and transport are stopped, and the | |
|
|
| machine is disabled. | |
|
|
| Transfer images from the image buffer to the | |
|
|
| host system. | |
|
|
| ||
|
|
| Press the Run key to continue. | |
|
|
|
|
|
| E298 | Calibration required | Enter function code F37 to initiate the calibration | |
|
|
| sequence. | |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|