Kodak i1800 Series manual Message listing, A-61555March

Message listing

Following is an alphabetic list of messages and corrective actions you can take if one of the following messages is encountered.

Messages	ID#	Operator Message
Background accessory changed	381	The Background Accessory was changed while the scanner was
while powered up		powered on.
		• Turn the power off to the scanner, wait a few seconds and
		power the scanner back on.
		• If you get this message and you did not change the
		Background Accessory, clean the scanner.
Cable unplugged	319	Some device on the FireWire bus was unplugged/plugged in.
		• Check that all FireWire connectors are securely fastened.
Calibration failed	106, 331	• Clean the imaging guides. See Chapter 5, Maintenance for
		procedures.
		• Try to calibrate the scanner again. Be sure you are using the
		correct calibration target. See Chapter 3, “Calibrating the
		scanner”.
		• The calibration target is too small. A 12- x 12-inch calibration
		target is required for image calibration.
		• Calibration target is too narrow.
		• If the problem persists, call Service.
Calibration succeeded	105, 342	Informational message. The scanner has been successfully
		calibrated.
Call Service	Many ID	A condition was detected that may require repair.
	numbers	• Turn the power off to the scanner, wait a few seconds and
		power the scanner back on.
		• If the problem persists, call Service and provide the ID number
		of the error.
Cannot calibrate with white	184	Both a front and rear print head is installed in the scanner. Only
background		one print head can be installed at one time.
		• Remove one of the print heads.
Cannot run with both printers	90	The White Background Accessory is installed in the scanner
installed		while the scanner is trying the calibrate.
		• Remove the White Background Accessory before calibrating
		the scanner.
Check document preparation	123, 135,	• The gap between your documents is too small.
	81	• Make sure the leading edges of the documents are aligned.
		See Chapter 3, “Document preparation” for more information.
		• Check the condition of your feed module and separation roller
		tires and your pre-separation pad. Clean and replace if
		necessary.
Check imaging guides and lamps	149, 178,	• Verify that the imaging guides are installed correctly. See
	139	Chapter 5, Maintenance.
		• Clean both sides of the imaging guides and lower glass plate
		between the lamps.
		• Check that the white patch on the imaging guides is clean and
		in good condition.
		• If the problem persists, call Service.
Clean lower imaging guide	294	The lower imaging guide is dirty or there may be a small piece of
		paper in the imaging guide area.
		• Clean the imaging guides. See Chapter 5, Maintenance for
		procedures.

A-61555 March 2007 6-5