Messages | ID# | Operator Message |
UDDS calibration failed | 333 | The UDDS calibration failed. |
|
| • Be sure you are using the correct ultrasonics calibration target. |
|
| See Chapter 3, “Calibrating the scanner”. |
|
| • Clean the sensors and try again. |
|
| • If the problem persists, call Service. |
UDDS calibration succeeded | 332 | Informational message. The scanner ultrasonics has been |
|
| successfully calibrated. |
|
|
|
UDDS is not calibrated | 21 | • Perform an Ultrasonics calibration. See Chapter 3, “Calibrating |
|
| the scanner” for procedures. |
|
|
|
UDDS | 23, 24, 334 | A |
|
| • Check the host monitor to see if there are any overlapped |
|
| documents that may need to be rescanned. |
|
| This condition may be caused by: |
|
| • Poor document separation causing overlapped documents. |
|
| • Stickers on the documents. |
|
| • Wrinkles in the documents |
|
| • Thick documents with high |
|
|
|
Unable to scan | 5 | • The previous error condition has not been corrected. For |
|
| example, there could be a document jam that has not been |
|
| completely cleared. |
|
| • Incomplete or conflicting image processing parameters. |
|
| • See other log entries for the actual condition. |
