Troubleshooting | This section lists possible problems you may encounter when using the | |
| Kodak Digital Science Super12 Document Printer. | |
|
|
|
Problem |
| Solution |
|
| |
Printing a partial image or printing | Be sure the Super12 Document Printer is seated correctly | |
backwards |
| on the printer bracket. |
|
| |
Experiencing print problems at startup | ∙ Press Stop and wait approximately 5 seconds for the | |
due to heads drying up |
| Super12 Document Printer to reach the capped position |
|
| before opening any doors, performing any printer |
|
| functions or turning off any switches. |
|
| ∙ Press F48 (Auto Purge). |
|
| ∙ Press F45 (Test Pattern). |
|
| |
Image is drifting from the desired print | See the next section entitled “How print position is effected | |
location |
| by patch reading” for more detailed information. |
|
|
|
Poor print quality |
| If you are experiencing poor print quality, check the |
|
| following: |
|
| ∙ Check to be sure the print cartridges are not empty. |
|
| If you are using a black print cartridge, check the |
|
| Full/Empty indicator to see how much ink remains in the |
|
| cartridge. If it is empty, insert a new print cartridge. |
|
| If you are using a red print cartridge, weigh the print |
|
| cartridge to be sure it has an adequate ink supply; a full |
|
| print cartridge weighs approximately 110 grams; an |
|
| empty print cartridge weighs approximately 70 grams. |
|
| ∙ Use F56 to verify that all jets are functioning properly. |
|
| ∙ Clean the wipers and gaskets. See the procedures in |
|
| the section entitled, “Maintenance”. |
|
| When finished: |
|
| ∙ Press F48 (Auto Purge). |
|
| ∙ Press F45 (Test Pattern). |
|
|
|
24 |