ISTTI
STRUT FIISE SI, WS, EII
TE: Refer to the Design Guide section of this manual for finished basin and wall material recommendations and information.
Install the finished basin, walls, and ceiling materials according to established installation methods. For the suction assembly and K6717 Drain, the wall must be 3/4 to 163/46inches thick. The total thickness of the basin (basin material and finished floor material combined) must not exceed 161/46inches at the drain for the K6717 Drain. Refer to the installation instructions packed with the drain for specific details.
Cut or drill holes for the tower, keypad, water supplies, suction, drain and drain overflow, as well as any light fixtures or other accessories.
ER: | Risk | of | dath or srious | ||
injury. Gaps between | the | suction | cover and | ||
the finished | basin | material | present | a serious | |
hair entrapment hazard. The finished basin material must be constructed so the suction cover installs against a flat, smooth surface. Carefully repair or seal all gaps.
Finish the basin wall surface so it is perfectly flat and smooth within the 56inch diameter area around the suction hole.
IST SUTI SSEY
Apply a thin bead of clear, high6quality silicone sealant around the flange rim and on the threads, and insert the flange into the bushing. Securely thread the flange to the bushing.
Remove any excess sealant.
Install the suction cover and metal spacer (if included) to the flange with the suction cover screw. Use a screwdriver to tighten the suction cover screw until snugo. not ovrtightnIn. addition, make sure all the suction cover holes are clear and unobstructed to maximize performance. Press the plug button in place over the screw head.
Permanently secure the suction bracket and pump box to the wall and floor, if desired.
Allow the sealant to fully cure.
116347626 (A) | 20 | Kohler Co., Kohler, WI |
