INSTALL THE KEYPAD
CAUTION: Risk of personal injury or
product damage. The metal plate must be installed flush with the finished wall or slightly recessed (maximum 1/41inch)
Feed the cable through the hole in the metal plate Use two flathead screws to attach the metal plate to the outlet box or finished wall material so the
metal plate flushis with the finished wall or slightly recessed (maximum 1/41inch)
Snap the keypad modular plug into the keypad cable jack
Apply silicone sealant to each of the keypad screw holes and around the keypad edges, and secure the keypad to the metal plate with four panhead screws
CAUTION: Risk of personal injury or product damage. Prevent water damage to the keypad by applying silicone sealant as instructed
IMPORTANT! Apply a continuous bead of clear silicone sealant to the cover plate sealant grooves, as shown.
Slip the center pin at the top of the cover plate up through the hole in the keypad Secure the cover plate to the keypad with a panhead screw
Select the bottom cap - it contains a small pinhole, and has a small notched area along the contact surface edge
IMPORTANT! Apply clear silicone sealant to
the back surface of the bottom cap, and also to the edge that contacts the cover plate. Align the bottom cap holes with the cover plate pins, and push the cap into place. Repeat for the top cap.
Remove any excess sealant
INSTALLATION
Check Point #9
-Faucet trim and spout installed.
-Drain assembly installed.
-Footbath basin filled with water and checked for leakage.
-Door enclosure installed.
-Tower installed.
-Keypad installed and sealed with silicone sealant.
-Keypad wiring connections made.
11347121AA (A) | 23 | Kohler Co, Kohler, WI |
