Kohler 14/20RESAL manual Networking Configuration Submenu OnCue Password

3.18.2Networking Configuration Submenu (OnCue Password)

The networking Configuration menu includes settings used for communication with the Kohlerr OnCuet Home Generator Management System.

For most applications, DHCP is enabled and the IP settings cannot be changed from the controller keypad. If DHCP is enabled, IP parameters are not displayed.

If DHCP is disabled (i.e., if a static IP address is required), then the IP parameters can be modified. For applications that require static IP addresses, press and hold the select button to enable editing, disable DHCP, and then step to the next parameters and enter the information.

If an error occurs while setting a parameter, an error message is displayed and then the controller exits the edit mode. Previous settings are preserved.

Password

For the initial OnCue setup, you will be required to reset the OnCue password on the RDC2 controller, and then enter it into the OnCue software. To reset the password, follow the instructions in Figure 3-21.

Note: The password is displayed for only 10 seconds. Be sure to write down the password and serial number.

A new password is generated each time the reset password procedure is performed. If the password is reset after the OnCue system has been set up, the connection will be lost. Enter the new password in OnCuer to reconnect.

Networking---->

Information

Networking---->

Status

Networking Configuration

Reset OnCue Password

DHCP:

Enabled

HOLD

Reset OnCue

Password? No

UP arrow for YES,

Down arrow for NO.

Reset OnCue

Password? Yes

Press Select to enter YES or NO as displayed. New password is displayed for approximately 10 seconds.

S/N: 1234567

New PW: 12345

<---- Return

tp6804

Figure 3-21 Network Configuration Submenu

TP-6804 12/11 Section 3 RDC2 Controller Operation 45