FACE COUNT | A | |
until now with this printer is displayed. | ||
| ||
|
| |
CONTROLLER | The controller firmware version is displayed. | |
VER. | ||
| ||
|
| |
ENGINE VER. | The printer engine firmware version is displayed. | |
|
| |
DIMM TEST | A complete DIMM test is performed, allowing you to check that there are no | |
errors in the DIMM. | ||
| ||
|
| |
SDRAM TEST | A complete SDRAM test is performed, allowing you to check that there are | |
no errors in the SDRAM. | ||
| ||
|
| |
POWER ON TEST | A Power On test is performed. Wait until the test is finished and “IDLE” is dis- | |
| played. | |
RESET COUNTER | Use this after replacing the transfer unit. | |
TRANSFER UNIT |
| |
| The settings for Energy Saver, Auto Continue and Chaining Tray are | |
RESTORE USER | returned to their defaults. | |
The default settings are listed below. | ||
DEFAULT | Energy Saver: 30 minutes | |
| Auto Continue: On | |
| Chaining Tray: On | |
|
|
•If the printer is connected and used on a network, the following settings should be speci- fied.
•For details about each setting, contact your network administrator.
IP ADDRESS | Set the IP address of this printer on the network. | |
Using the Up, Down, Prev. and Next keys, enter the value. | ||
| ||
|
| |
SUBNET MASK | Set the subnet mask value of the network. | |
Using the Up, Down, Prev. and Next keys, enter the value. | ||
| ||
|
| |
GATEWAY | If a router is used on the network, enter the IP address of the router. | |
Using the Up, Down, Prev. and Next keys, enter the value. | ||
| ||
|
| |
HW ADDRESS | The Ethernet hardware address for this printer can be seen. (It cannot be | |
changed.) | ||
| ||
|
| |
HTTP | This specifies whether or not PageScopeLight can be accessed. | |
|
| |
SNMP | This specifies the access privileges for the MIB file. | |
|
| |
| DHCP: If there is a DHCP server on the network, set whether or not the IP | |
| address is automatically assigned by the DHCP server and other network | |
DHCP/BOOTP | information is loaded. | |
BOOTP: Set whether or not the IP address is automatically assigned by | ||
| ||
| BOOTP and other network information is loaded. | |
| Either can be set to “On” or both can be set to “Off”. | |
|
|
BLACK TONER | Indicates the percentage of black toner remaining in the cartridge. |
XXX% REMAINING | |
|
|
YELLOW TONER | Indicates the percentage of yellow toner remaining in the cartridge. |
XXX% REMAINING | |
|
|
135