Korg BX-3 manual Group 8 Program Name

Parameters

Amp Gain Ctrl Min (Amp Gain Control Minimum) [0...99]

Specify the minimum setting of the Normal Edit mode and EX Edit mode Group 4 “Amp Gain” parameter. This will be the gain when the expression pedal etc. specified by the “Amp Gain Ctrl” parameter is in the minimum position.

Amp Gain Ctrl Max (Amp Gain Control Maximum) [0...99]

Specify the maximum setting of the Normal Edit mode and EX Edit mode Group 4 “Amp Gain” parameter. This will be the gain when the expression pedal etc. specified by the “Amp Gain Ctrl” parameter is in the maximum position.

Rev Mix Ctrl (Reverb Mix Controller)

[Off, Pedal 1/(Pdl 1)*, Pedal 2/(Pdl 2)*]

Pedal 1: An expression pedal etc. connected to the rear panel ASSIGNABLE PEDAL/SW 1 jack will control the Group 5 “Reverb Mix Level” parameter of Normal Edit mode and EX Edit mode.

Pedal 2: An expression pedal etc. connected to the rear panel ASSIGNABLE PEDAL/SW 2 jack will perform the above operation.

Off: No function.

Rev Mix Ctrl Min (Reverb Mix Control Minimum) [0...99]

Specify the minimum setting of the Normal Edit mode and EX Edit mode Group 5 “Reverb Mix” parameter. This will be the reverb mix level when the expression pedal etc. specified by the “Reverb Mix Ctrl” parameter is in the minimum position.

Rev Mix Ctrl Max (Reverb Mix Control Maximum) [0...99]

Specify the maximum setting of the Normal Edit mode and EX Edit mode Group 5 “Reverb Mix” parameter. This will be the reverb mix level when the expression pedal etc. specified by the “Reverb Mix Ctrl” parameter is in the maximum position.

Group 8: Program Name

Rename

Here you can modify the name. You can use up to twelve characters.

Use the [√ ][®] keys to select the character that you wish to change, and use the [–]/[+] keys to select the character. The following characters can be used.

* (Pdl 1), (Pdl 2): These indicate that Pedal 1 or Pedal 2 are selected for the Global mode Group 1 “Prog Up Ctrl” or “Prog Down Ctrl” parameters. With these settings, the settings of
Global mode are used, and the settings you made here will be ignored. However if you select another value in Global mode, the display here will change from (Pdl 1) to Pedal 1 or	29
from (Pdl 2) to Pedal 2, and you will be able to operate the corresponding function from the pedal switch.